Metal Hot end, V6 Direct Drive, 3mm filament, 0.4mm Nozzle

Metal Hot end, V6 Direct Drive, 3mm filament, 0.4mm Nozzle

Micro Swiss All Metal Hot End Upgrade for CR-10 Pro

Micro Swiss All Metal Hot End Upgrade for CR-10 Pro

Dual metal Bowden hot end, 1.75mm filament, 0.4mm Nozzle

R599.00 R520.87
Selected Store: Centurion Store : 88 In Stock
Boksburg Store : 2 In Stock

SKU
HOT040

This Dual Metal Hot End is based on the original E3D Chimera Hot End design.  This hot end is not manufactured by E3D, but is the generic version.  This hot end is a 2 in 1 system with 2 hot ends in one heat sink for dual extrusion.  It is simple to set the height of each hot end as the heat break clamps in the heat sink with two screws.

The filament is fed into the hot end via a 4mm PTFE tube which runs through the hot end down to the nozzle.  This ensures a low friction path for the filament to run through.  The hot end comes with 0.4mm brass nozzles, 12V heater cartridges, 100k thermistors and 12V fans.

Note: It is possible that the hot end might leak plastic at the heater block when it is used for the first time.  This is because the nozzle was tightened at room temperature and when the hot end is heated up to printing temperature, a small gap is created between the nozzle and the heat break.  To solve this, loosen the grub screw that locks the nozzle (if present) and heat the hot end to printing temperature.  Hold the heater block with pliers and tighten the nozzle with a spanner a little bit at a time so that the nozzle seats on the heat break.  When done, tighten the grub screw onto the nozzle again.  Please see the Product Videos section for a video on this or watch the YouTube video here.

More Information
SKUHOT040
Length2.0000
Width3.0000
Height8.0000
Weight0.0600
Write Your Own Review
Only registered users can write reviews. Please Sign in or create an account