Heat Break for E3D V6, 1.75mm filament, with PTFE Tube
Boksburg Store : 15 In Stock
This is a heat break compatible with the E3D V6 hot end for 1.75mm filament. This is a PTFE lined heat break which allows for a very robust hot end configuration. Tip: You might need to heat up the heater block during assembly due to the plastic in the heater block. We find a heat gun works very well for this.
- Material: Stainless Steel
- Thread on top section: M7
- Thread on bottom section: M6
- Inner Hole diameter: 2.0mm (Including PTFE)
- For filament diameter: 1.75mm