Thermistor, 100K Ohm, NTC, 3950 1%, with cable

Thermistor, 100K Ohm, NTC, 3950 1%, with cable

Proximity sensor, M12, 6-36V, NPN, Normally Closed

Proximity sensor, M12, 6-36V, NPN, Normally Closed

Relay, 30A, 12V

R79.95 R69.52
Selected Store: Centurion Store : 90 In Stock
Boksburg Store : 7 In Stock

SKU
RLY001

This is a relay capable of switching 30A of current.  It is switched by a 12V signal.  The relay can be connected to be normally open or normally closed, depending on your setup and can be set to a high level trigger or low level trigger.  It uses an EL817 photoelectric coupler for isolation.

This is used to switch your heated bed on and off when your heated bed needs to run off a higher voltage than your electronics or the current is more that the electronics can handle.  So if you have for instance a RAMPS board controlling your printer, but you have a large heated bed running off 24V or your heated bed pulls more than 10A of current then the switch on the electronics is not suitable to drive the heated bed.  Then you can use the heated bed output from the electronics to switch the relay and connect the heated bed to the power supply via the relay.

Specifications:

  • Current capacity: 30A
  • Switching voltage: 12V
  • Can be connected as Normally Open or Normally Closed
More Information
SKURLY001
Length5.0000
Width5.0000
Height5.0000
Weight0.1000
Write Your Own Review
Only registered users can write reviews. Please Sign in or create an account