Volcano nozzle for 1.75mm filament, 0.6mm
Boksburg Store : 1000 In Stock
This nozzle is based on the Volcano hot end and works with the E3D Volcano heater block. It uses the exact same cold end as the E3D Hot end, it is only the heater block and nozzle which is different.
The Volcano is a high flow hot end for high speed printing. It has an extra long melt pool, which gives the material enough time to reach the required temperature at high flow rates. Another improvement is that the heater cartridge is mounter parallel to the nozzle, which increases the heat transfer between the heater cartridge and the nozzle.
- This nozzle is used with the Volcano heater block on the E3D Metal Hot End
- Material: Brass
- Filament diamter: 1.75mm
- Nozzle size: 0.6, 0.8, 1.0, 1.2mm (Please choose from selection above)
- Interface: M6 Thread